Tower Crane TC5512

Parameter

 Hoisting
Mechanism

Electromotor

Model

YZTD225L2-4/8/32

Power

Kw

24/24/5.4KW

Reducer

Model

JD566

Steel rope

12NAT6X19W

Slewing
Mechanism

Electromotor

Model

YTLEJ112L-55-4

Power

N.m

2x55

Turning rate

R/min

960

Reducer

Model

XX4-80.195C

Trolleying
Mechanism

Electromotor

Model

YDEJ132S-4/8

Power

Kw

8

Turning rate

R/min

700/1450

Reducer

Model

BXJ45

Speed Ratio

i=45

Steel rope

8NAT6X19W

Power

Kw

5.5

Hydraulic pump

Cylinder model

HSGK01-169/110BE

Route of travel

mm

1600

Discharge of Hydraulic pump

L/min

11

Working Pressure

MPa

20

Mast Section

External Dimensions
1645×1645
Overall Height:2800

The mast composition consists of a quantity of standard sections. The number of standard sections is determined by the height of the crane. Standard section consists of main chord, horizontal brace and tilting brace, which are welded to a spatial trussing. The length of each standard section is 2.8m, the section size is 1.645×1..645m

Jib

The hoisting jib is non-uniform section and isosceles triangle type, the upper and lower chord is a square tube welded by two angle bars, the tilted brace and horizontal brace are made of seamless tube. Both the upper and the outside surface of the lower chord are kept horizontal and vertical, thus, the lower chord can also be used as a rail for jib trolley.

Tower Cap

The cat head is a triangular spatial trussing. The front and rear chord is welded as a square tube by two angle bars, the brace of which is made of the seamless tube. Its bottom is connected with the slewing tower by pin roll. The front and rear side of which are installed with pulling plates that hinged to tie bar of the hoisting jib and the counter jib respectively. The upper part of the cat head has a platform, the installation person can stand on it to disassemble the crane and thread the hoisting wire rope.

Upper and lower pedestal are case structure welded by plate.
                                                                                 

Counter jib

The counter jib is a spatial trussing composed of four angle bars.
The hoisting mechanism locates at the rear of the counter jib and the counter blocks are located at the tail.

Frame

Space frame structure welded by channel steel, angle steel and steel board

Jib Tie Bar

Tie bar of the jib is welded by the solid round steel.